Valor Fires 845 User Manual download pdf (Page 10)

The heater must be secured into position to prevent it from being tipped over.

The following securing options are available:

 Method A - Securing the heater with Screws.

 Method B - Securing the heater with Wire.

 Method C - Securing the heater using the Spacer Frame supplied with the

heater.

 Method D - Securing the heater using the Optional Spacer Frame (kit number

0582631).

If fitting the heater into a fireplace or surround opening, try the heater in the opening

to ensure that it will fit.

If fitting the heater onto a decorative hearth surface such as marble or tile it is

advisable to protect the hearth surface. Do not drag the heater as the surface finish

may be damaged.

Method A - Securing with screws.

Note - If fixing to marble it is recommended that

Method B - ‘Securing with wire’ is used. Drilling

marble without the correct tools and experience may

result in the marble cracking.

1. Place the heater into the fireplace or surround

opening. Make sure that the heater is in the middle

of the surround or fireplace.

2. There are two slotted holes in the top of the heater

and four holes in the side flanges (See figure 4). We

recommend the use of two upper holes and two

lower holes. Mark through the required holes so that

their position is clear when the heater is removed.

3. Remove the heater.

4. Drill an appropriate size hole in each of the

marked positions for the wall plugs supplied. Insert

wall plugs into the drilled holes.

5. Place the heater so that the holes are in line with

the wall plugs in the fixing surface.

6. Screw and secure the heater with four wood screws - (See figure 3 and 4).

Method B - Securing with wire.

This method of securing is recommended where the wall / brickwork is in poor

condition or where marble back panels / surrounds are used.

Figure 4. Screw location

INSTALLER AND OWNER GUIDE

Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Valor Fires 845 User Manual Page 10