Valor Fires 940 Owner's Manual download pdf (Page 9)

Remote Control Operation

When the pilot is off, it will take 2

minutes before it can be lit again.

TO TURN ON APPLIANCE TO TURN OFF APPLIANCE

FLAME HEIGHT ADJUSTMENT

• On the valve, turn MAN knob on the ON, full

counterclockwise position.

• Place ON/OFF switch (if equipped) in I (ON

position).

STANDBY MODE (Pilot Flame)

• Press and hold (small ﬂ ame) to set appliance at

pilot ﬂ ame.

• Simultaneously press the OFF and

(large ﬂ ame) buttons until a short

beep conﬁ rms the start sequence

has begun; release buttons.

• Continuing beeps conﬁ rm the

ignition is in process.

• Once pilot ignition is conﬁ rmed,

there is main gas ﬂ ow.

• After main burner ignition the

handset will automatically go into

manual (MAN) control mode.

• Press OFF button.

When the pilot is off, it will take 2

minutes before it can be lit again.

• In standby mode: Press and hold

(large ﬂ ame) button to increase

ﬂ ame height.

CAUTION

When pilot ignition is conﬁ rmed, motor turns

automatically to maximum ﬂ ame height.

NOTE: Before using the remote control system

for the ﬁ rst time, the receiver and the handset must

be synchronized. See the sub-section Set-up Remote

Control on page 37 of this manual.

Set (scrolls

through

modes and

settings)

OFF (returns

to set mode,

turns the burner

and the pilot o)

Large ame

button (ames

up, sets hours,

temperature)

Small ame

button (ames

down and o,

sets minutes,

temperature)

Current

temperature

(F or C)

Current time

(12 or 24 hour clock)

Modes (Manual,

Temperature, Timer)

Handset

sensor

Battery status

Current

programmed

period (Timer)

Period

start or end

(Temp, Timer)

Display Overview

Handset Overview

Note: In the TEMP or TIMER modes, the remote

handset senses the room temperature and adjusts the

ﬂ ame accordingly.

To communicate, the handset should be within 15 feet

(4.5 meters) of the ﬁ replace.

Do not leave the handset on the mantel or hearth.

IMPORTANT: BEFORE YOU BEGIN, please note that

on this system, the settings of time, temperature and

automatic ON/OFF can only be programmed when

the function display is ﬂ ashing. Be patient when

programming as it can take a few seconds to set.

OWNER’S

INFORMATION

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Comments to this Manuals

No comments

Valor Fires 940 Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Fireplaces Valor Fires 940